|
|
|
AIMNET
PANEL |
| |
The AIMNET Smart Building
panel is the central point of your facilities services.
Our panels contain the complete array of services that
are a part of your Smart Building System. Your AIMNET
panel connects back to the AIMNET central monitoring
center via an Internet connection. Each system, office,
device or AIMNET Port is wired from its location back to
the AIMNET panel.
AIMNET panels are normally installed by an electrician
or an AIMNET dealer. Your electrician simply provides
power to the panel and then wires from the panel to each
device and port according to specific wiring diagrams we
furnish. Each panel contains numbered and color coded
terminals as the wiring termination point. Easy to
install and wire with all configuration and setup
performed from our central monitoring station. |
|
|
Custom designed and built for your specific needs. |
|
| |
|
All AIMNET panels are custom designed according to the
buildings specific requirements. Our engineers perform a
complete survey of the needs, the types of equipment and
the extent of services. They then design a panel
containing all the technology required in an Integrated
package. |
 |
All AIMNET panels are custom designed according to the
buildings specific requirements. Our engineers perform a
complete survey of the needs, the types of equipment and
the extent of services. They then design a panel
containing all the technology required in an Integrated
package.
Panels are shipped to the project site complete. Your
installer simply hangs it on a wall and runs wire to the
specific AIMNET port locations or devices. Our engineers
produce complete point to point wiring diagrams to make
the wiring process very easy. Other than a 120volt power
supply all wire extended from our panels is either CAT5
/ CAT6 network cable or low voltage wire. Coded
termination strips within the panel make it quick and
easy to wire.
AIMNET Energy Management Systems which are normally
provided within the panel also include all required
devices and sensors required for installation on the
mechanical and electrical systems. Devices used in
monitoring and managing HVAC services are normally
installed by an HVAC or mechanical contractor.
Electrical devices such as switches, VFD's and or
lighting controls are normally installed by an
electrician.
All in all installing and wiring Smart Building panels
is very easy and typical to any normal work performed by
qualified contractors. There is nothing about our
systems that is new or unfamiliar to typical trade
contractors.
|
|
|
